Are you taking CLEP classes? Try clep.ai
| preferred AP College board partner for AP classes
AP Networking/Unit 3: Managing Many Connections
Start Practice TestPractice Test
About Exam
hard

Router on a Stick Port Configuration

Mark
< Prev
Next >

A network technician is troubleshooting connectivity between two departments. Sales hosts are in VLAN 10 (192.168.10.0/24) and HR hosts are in VLAN 20 (192.168.20.0/24). All hosts have their respective default gateways correctly configured.

A router is connected to the Layer 2 switch via a single physical link on switch port FastEthernet0/24. The router’s interface is configured with two subinterfaces, each using 802.1Q encapsulation matching the VLAN IDs and holding the correct default gateway IP addresses.

Currently, Sales hosts can ping other Sales hosts, but cannot ping HR hosts or their own default gateway. The switch port FastEthernet0/24 is configured with the commands “switchport mode access” and “switchport access vlan 10”.

Based on the provided evidence, why is inter-VLAN connectivity failing in this topology?

A

The hosts in VLAN 10 are attempting to use ARP to resolve MAC addresses in VLAN 20 instead of sending traffic to the gateway.

B

The switch port connected to the router is operating as an access port rather than an 802.1Q trunk.

C

The Layer 2 switch lacks the routing table required to forward packets directly between VLAN 10 and VLAN 20.

D

The router requires two separate physical interfaces to route traffic between two distinct VLANs.

Did You Know?
Explain Why
Explain All Answers
Check Answer
Show Correct Answer
Report Question

Question Leaderboard

Not enough data yet to show leaderboard.

No comments yet. Be the first to comment!

AI Tutor

How can I help?

APFIVE © 2020.
Email: apfive@apfive.org|Instagram: @_apfive_|Privacy Policy|